Hook for Wall-mounted Pot

Indoor (Plasterboard/timber) installation

• Take time to determine the right location for your pot. Place the pot close to a window to maximise natural light exposure.

• Hold the pot against the wall to see that the height is right. Then lift the inner cup out of the outer pot to ensure that it's convenient.

• Once you've found the right spot, locate a timber stud to maximise load capacity. Then, use a pencil or a pen to mark the position where you'd like to install the hook. 

• Tap the nail until the hook is flush with the wall (see image).

• Hang the pot. If required, adjust the hook down slightly with your fingers.

Indoor (Masonry) installation

• Take time to determine the right location for your pot. Place the pot close to a window to maximise natural light exposure.

• Hold the pot against the wall to see that the height is correct. Then lift the inner cup out of the outer pot to ensure that it's convenient.

• Once you've found the right spot, use a 5mm drill bit to create a 25 mm hole.

• Insert the white plug into the hole.

• Insert the screw through the hook and use a screwdriver to tighten it into the plug, ensuring that the screw is tight against the wall.

• Hang the pot. If required, adjust the hook down slightly with your fingers.

Outdoor installation

• Take time to determine the right location for your pot. Place the pot close to a window to maximise natural light exposure.

• Hold the pot against the wall to see that the height is correct. Then lift the inner cup out of the outer pot to ensure that it's convenient.

• Once you've found the right spot, use a 6mm drill bit to create a hole 45 mm deep.

• Insert the anchor through the fixture and tap with a hammer until the collar of the anchor is flush with the wall) (see image).

• Tighten the screw until the head of the screw is a few millimetres from the anchor.

• Hang the pot. If required, turn the hook to adjust the depth.